GYMDONE
← Back to the blog

Muscle Groups: The Major Muscles and the Best Exercises for Each

GYMDONE editorial team

Muscle Groups: The Major Muscles and the Best Exercises for Each

The major muscle groups you train in the gym are the chest, back, shoulders, arms (biceps and triceps), core, glutes, quadriceps, hamstrings and calves. A balanced program trains each of them at least twice a week, usually with one or two exercises per group. A push works the chest, shoulders and triceps, and a pull works the back and biceps. You'd use a squat or lunge for the quads and glutes and a hip hinge for the hamstrings and glutes, and the calves and core get a little direct work on top.

You don't need a separate exercise for every muscle. Squats, presses, rows and other big multi-joint movements train several muscle groups at once, so a well-chosen workout of six or seven exercises covers the whole body. The map below shows each muscle group with the exercises that train it best in the gym and at home.

The major muscle groups and the best exercises for each

Treat the table as a menu. The gym column gives you, for every muscle group, the exercises with the best mix of load and range of motion. In the home column you'll find versions that need only dumbbells, a bench or your bodyweight.

Muscle groups, what they do and how to train them
Muscle groupMain muscles and their jobGymHome or dumbbells
ChestPectoralis major and minor; push the arms forward and togetheror
BackLatissimus dorsi, trapezius, rhomboids; pull the arms down and backandor
ShouldersDeltoids (front, side and rear); lift the arms in every directionandor
BicepsBiceps brachii and brachialis; bend the elbow
TricepsTriceps brachii; straighten the elbow
CoreRectus abdominis, obliques, deep trunk muscles; bend, brace and resist twistingor
GlutesGluteus maximus, medius and minimus; extend and stabilize the hip
QuadricepsFour muscles on the front of the thigh; straighten the kneeoror
HamstringsThree muscles on the back of the thigh; bend the knee and extend the hipor
CalvesGastrocnemius and soleus; point the foot and push off the ground

Some groups get a lot of work without any direct exercises. Whenever you press, your triceps and front shoulders work along with your chest. Rows and pulldowns bring in the biceps and rear shoulders along with the back, while squats and Romanian deadlifts load the glutes and the muscles along the spine. For that reason, our guide to compound vs isolation exercises recommends making compound lifts the base of a workout and adding isolation work for the groups that still lag. Single areas get their own deeper guides: the back workout, glute workout and ab workout.

A full-body workout that covers every muscle group

Together, the two sessions below cover every major muscle group. You alternate them on three non-consecutive days, so you might do A, B, A one week and B, A, B the next, as in our 3-day full-body workout. For a warm-up, do a few minutes of easy cardio and one or two light sets of the first exercise. Between sets, rest about 2 minutes on the big lifts and 60–90 seconds on the small ones.

  • Day A3 × 8–103 × 8–103 × 10–122 × 12–152 × 12–152 × 12–15
  • Day B3 × 8–103 × 8–103 × 10–122 × 10–122 × 10–122 × 12–15

Count on about 45–55 minutes per session. At home, swap each exercise for its home version from the table above; a pair of adjustable dumbbells and a bench cover almost everything. If four shorter sessions a week suit you better, the same exercises split well into an upper/lower routine.

How much to train each muscle group

Two numbers matter most: how often each group is trained and how many hard sets it gets per week. One meta-analysis of studies comparing training frequencies found more growth from working a muscle group twice a week than once, when the total volume was similar (Schoenfeld, Ogborn and Krieger, 2016). The American College of Sports Medicine says the same in plain terms in its 2026 resistance training guidelines: train all major muscle groups at least twice a week, and if muscle growth is the goal, aim for about 10 sets per muscle group per week (ACSM, 2026).

Weekly sets and muscle growth showed a graded relationship in a second meta-analysis. More sets brought more growth, and 10 or more weekly sets per muscle did better than fewer than 5 (Schoenfeld, Ogborn and Krieger, 2017). If you're new to lifting, start near the low end, with 2 sets per exercise, and add sets only when you recover well between sessions. Counting sets gets trickier when one exercise trains several groups, and our guide to training volume per muscle deals with that.

Whatever the volume, muscles grow only if the work gets harder over time. Take a repetition range like 8–12, add weight once every set reaches the top of it with good form, and track all this so the trend is visible. This is progressive overload, and it matters more than which exact exercise you pick from the table.

Common mistakes

  • Training only the mirror muscles. Chest, biceps and abs are easy to see. Leave out rows, hip hinges and leg work, though, and the program leads to imbalances. A push, a pull, a squat and a hinge belong in every week.
  • One body part per day, once a week. That's the classic "bro split", and it trains each muscle group only once a week. Most people grow faster with two sessions per group.
  • Forgetting the back of the body. Hamstrings, glutes, rear shoulders and the upper back often don't get enough work. Add a row if your plan has more pressing than pulling.
  • Too many isolation exercises. Five arm exercises and no squats take a lot of time for little result. Start with compound lifts, and only then add one or two isolation exercises.

Common questions

How many muscle groups are there?

Your body has more than 600 muscles, but for training they're usually grouped into 9–11 major muscle groups: chest, back, shoulders, biceps, triceps, forearms, core, glutes, quadriceps, hamstrings and calves. Gripping during rows and deadlifts gives the forearms most of their work.

Should I train one muscle group per day?

You can, but then each group usually gets trained only once a week. Twice a week for every group is easier to reach on a full-body, upper/lower or push/pull/legs routine.

Which muscle groups can I train together?

Muscles that work together make natural pairs: chest, shoulders and triceps (pushing), back and biceps (pulling), and quads, glutes, hamstrings and calves (legs). Core work can go on any day.

Is it safe?

These are standard exercises, but you should still start light, go up gradually and stop any movement that causes sharp pain. With an injury, a health condition or a pregnancy, get advice that fits your situation first.

Sources

Muscle Groups and the Best Exercises for Each One